Showing 0 products
Frequently Asked Questions
What does pleated media actually buy?
Filter area in a small space.
Pleating packs a lot of surface into a short cylinder.
A cartridge unit fits under an ordinary roof.
A baghouse of the same duty would not.
Footprint and headroom both drop sharply.
For most workshops that decides it.
Which dusts does it suit?
Fine, dry and free-flowing.
Grinding, cutting and blasting output.
Powder handling and woodworking dust.
The cake pulses cleanly off the pleats.
It runs continuously on that duty.
Dry is the operative word.
What ruins a cartridge?
Anything sticky, oily, moist or fibrous.
It packs into the pleats and will not pulse out.
Effective area collapses once pleats bridge.
The cartridge becomes scrap, not dirty.
This is the commonest misapplication.
Moist or oily dust needs other equipment.
How does the cleaning work?
Compressed air pulsed down each cartridge.
The shock snaps the cake off the pleats.
It happens while the unit runs.
Frequency rises as the media loads.
Compressed air use is a real running cost.
Demand-based cleaning reduces it.
What should be checked about change-out?
Where the cartridges come out.
Side access at working height is far better.
Reaching into a housing is unpleasant and slow.
That difference recurs at every change.
Ask to see the procedure, not the specification.
Clearance around the unit follows from it.
Does media selection matter much?
More than it usually gets credit for.
Coatings suit fine powders that would embed.
Anti-static media suits dust that charges.
Moisture resistant grades exist as well.
The right media extends life considerably.
Describe the dust, not just the process.
What signals a filter change?
Differential pressure across the media.
A gauge shows it directly.
Rising pressure means less airflow at the hood.
Capture suffers before anyone notices.
Set an action threshold, not a calendar date.
Record the baseline when new.