Showing 0 products
Frequently Asked Questions
What do these products have in common?
They act on the supply, not the load.
Changing it, cleaning it, holding it up.
Or correcting how it is drawn.
Nothing here does a useful job by itself.
They make everything else work.
Why does voltage ever need changing?
Because equipment and networks disagree.
Machinery arrives built for its home market.
Long runs drop voltage on the way.
Some loads need isolation from the supply.
All three are transformer problems.
Is bad power quality visible on a meter?
Usually not on a handheld one.
Averaging hides distortion completely.
Brief sags pass between readings.
Transients are far too fast.
Logging over a week is the honest test.
Which of the four does a given site need?
Whichever matches the measured fault.
Interruptions point to stored energy.
Distortion points to conditioning.
A billing penalty points to correction.
The symptoms look alike and the cures do not.
Should protection be central or at each load?
Central covers everything and costs once.
Local protects what genuinely matters.
Most buildings end up with both.
A server room rarely trusts the riser.
And a riser cannot cover a desk.
What ages fastest in this equipment?
Anything chemical.
Batteries lose capacity from the day they ship.
Capacitors dry out with heat and hours.
Magnetics and copper barely change.
So the consumables set the service plan.
Does this equipment run hot?
Hotter than the specification suggests.
High efficiency still leaves real kilowatts.
They all land in one small room.
Rooms are sized for the boxes.
Rarely for what the boxes reject.
Can one product cover several of these jobs?
Some combine two, none covers four.
An online standby supply also conditions.
Conditioners often include a transformer.
Nothing corrects power factor as a side effect.
Combined units suit small installations.
What is oversized here, and what is not?
Batteries get bought too small.
Runtime is quoted at a load nobody runs.
Transformers get bought too large.
They then sit at poor efficiency.
Both errors come from guessing the load.
What should be settled before anything is priced?
A week of measurement.
The real peak and the real waveform.
What must survive an outage, and for how long.
Where the heat will go.
Equipment choice falls out of those.