Showing 0 products
Frequently Asked Questions
What is usually the weakest part?
The fixing, not the bar.
Bars are made far stronger than needed.
The wall behind rarely is.
So the installation fails at the anchor.
Almost every time.
How is this different from a prewall support?
That one goes in before the wall closes.
Built into a new prewall as structure.
This one fixes to a wall already finished.
Where nothing can be put behind.
Use the prewall element if you still can.
What suits solid masonry?
Conventional or resin anchors directly.
It is the straightforward case.
Resin suits hollow or older blockwork.
And positions close to an edge.
Both give a rating worth having.
What about a timber stud wall?
Fine, if the bar lands on studs.
Which it frequently does not.
Studs sit at fixed centres.
And the bar goes where the movement is.
The two rarely coincide.
What if it cannot reach a stud?
A heavy toggle or spreader plate.
Purpose-made for board, not generic.
But the rating is far lower.
Than a fixing into structure.
Know which you have before relying on it.
What is a backing plate?
A plate across two or more studs.
Fixed before boarding and tiled over.
It makes the whole span fixable.
It is the honest solution.
And it is strictly first fix.
Which rating actually applies?
The installed one, not the bar's.
A 200 kilogram bar on a 40 kilogram fixing.
Is a 40 kilogram installation.
The box describes the bar alone.
Which is the most misleading figure here.