Showing 0 products
Frequently Asked Questions
What does pocket construction achieve?
Media area within the available depth.
Pockets extend back from a rigid header.
That holds far more area than a flat panel.
More area means longer service life.
Face velocity through the media falls.
Pressure drop rises more slowly.
Why does longer life matter more at temperature?
Media is expensive and access is awkward.
Hot installations are harder to reach.
Changing filters may require a shutdown.
Shutdowns carry production cost.
Fewer changes are worth more than the price difference.
Count the shutdowns, not just the filters.
What decides between bags and panels?
Housing depth, almost always.
Pockets need room behind the header.
A panel-depth track cannot take them.
Retrofits are usually constrained this way.
New housings can be built for either.
Measure before specifying.
What happens to pockets at high face velocity?
They can collapse against each other.
The area bought is then unavailable.
Pressure drop rises and life shortens.
Stitched separators keep pockets apart.
Internal supports do the same.
Confirm they are present rather than assuming.
Does thermal cycling affect them?
Yes, particularly at the header seal.
Repeated heating and cooling works the joint.
Media stiffens and can distort.
Batch processes age filters faster than continuous ones.
Allow for it in the change schedule.
Inspect the header at every opportunity.
Does airflow direction matter?
Absolutely, and reversal is immediate.
Pockets are designed to inflate one way.
Reversed, they collapse at once.
The filter is effectively destroyed.
Check the arrow before clamping.
Verify at every change.
How should they be inspected?
Visually as well as by pressure drop.
Look for pocket distortion and sag.
Check separation at the header seal.
Any of those passes debris downstream.
Hot media is fragile when disturbed.
Inspect at every planned shutdown.