Showing 0 products
Frequently Asked Questions
What does the bagging procedure achieve?
The operator never contacts the filter.
A bag is attached to a ring on the door.
The spent filter is drawn back into it.
The bag is sealed and cut while still gripped.
The contaminated side closes before it leaves.
Nothing escapes into the room.
When is this justified?
Against a defined hazard, not as an upgrade.
Nuclear and radiological applications.
Biological containment laboratories.
Potent pharmaceutical compounds.
Toxic or carcinogenic industrial dust.
Merely unpleasant dust does not need it.
Why does training matter so much?
The procedure has several steps.
A change done wrongly defeats the containment.
That failure is invisible afterwards.
Training and a written procedure are part of the purchase.
Refresher training matters where changes are rare.
Practise on a clean filter first.
How is the filter tested once installed?
In place, without opening the housing.
It cannot be inspected visually.
Upstream injection and downstream scan ports are needed.
Those must be designed into the housing.
Testing proves the installed seal, not the filter.
Specify the ports at purchase.
What are the consumables?
Change bags, and they are not generic.
Type and thickness are specified.
The wrong bag can tear during a change.
Ring diameter must match the housing.
Keep spares on site at all times.
Bags degrade in storage over long periods.
What happens to the spent filter?
It usually becomes regulated waste.
Classification follows what was captured.
The disposal route belongs in the design.
Storage before collection needs planning.
Costs can exceed the filter itself.
Establish it before the first change.
How much space does the procedure need?
Considerably more than the housing footprint.
The bag extends outward during a change.
The operator needs room to work.
A cramped position makes errors likely.
Mark the working zone at design.
It is not just filter withdrawal clearance.