Showing 0 products
Frequently Asked Questions
What do distributors and branch joints do?
They split one refrigerant line into several.
That lets one run serve multiple terminals.
Internal geometry divides flow correctly.
It divides entrained oil correctly too.
They are specified by the manufacturer, not generic.
Can standard pipe fittings be used instead?
No, and substituting them causes real problems.
A branch joint is a designed component.
Oil return depends on how flow divides.
Each manufacturer permits particular parts.
Warranty positions usually depend on it as well.
What does a branch selector box make possible?
Heating and cooling at the same time.
One zone can be heated while another is cooled.
It happens on the same refrigerant circuit.
Each indoor unit is directed to the right line.
Heat moves between zones instead of leaving.
Why is that worth having?
Because rejected heat becomes useful heat.
Buildings with disagreeing zones do this constantly.
Energy is recovered rather than thrown away.
It is the strongest argument for the system.
The benefit grows with zone diversity.
Can the capability be added later?
Not without changing pipework.
A heat recovery system needs a suitable arrangement.
A heat pump system switches its whole circuit.
There is no equivalent component to retrofit.
The decision belongs to the design stage.
Where should the boxes be installed?
Somewhere with permanent service access.
They contain valves and control components.
Some produce condensate needing a drain.
They are audible in operation.
A void above a quiet room is the wrong choice.
How many indoor units does one box serve?
A group, with the number set by the manufacturer.
Some boxes serve a single unit each.
Others serve several from one enclosure.
Layout and zoning influence the choice.
So does where access can be provided.